Designer:
Drive-in Bluetooth
Project Category:
Portable Speakers
Project Level:
Beginner
Project Time:
8-20 Hours
Project Cost:
$100-$500
Project Description:
This is an original drive-in movie speaker rig I picked up with the intentions of modifying/modernizing it for Bluetooth capabilities.
Design Goals:
I wanted a completely wireless, mobile Bluetooth speaker set up to take anywhere I want to go. I loved drive-in movies and thought it would be awesome to freak out family and friends when I fire this badboy up!
Driver Selection:
PC105-4 4″ poly cone speakers
Enclosure Design:
Speaker holder (top of pole )
Crossover Design:
N/A
Tips & Tricks:
No tips or tricks needed, just have fun and use your imagination.
Conclusion:
I did not want to sacrifice original speakers or the housing so I made my own control panel from 26ga. sheet metal. All wiring runs up through the housing using existing holes. I used Velcro to secure the circuit boards to the housing. The control panel is a simple 3 3/4″ x 4 1/2″ x 1 1/4″ deep box that I made and is secured to the top of the pole via 2 screws with nuts and lock washers. The speakers attached to the original housings with no modifications needed!
About the Designer:
Jack of all trades, master of none!
Project Parts List:
| Part # | Description | Qty. |
| 295-158 | Dayton Audio PC105-4 4″ Full-Range Poly Cone Driver | 2 |